Get in touch.
Dear,I will reply in 12 hours. All your message are protected!
And in doing the ABS prototype, often need to deal with the entire processing prototype customers, especially the length of more than one meter of the prototype, under normal circumstances, many prototype factory will use the split pieces to do the demolition of pieces, and ABS material Sticky is better, even after the demolition of pieces to go back, the impact of the intensity is not great, after the painting, basically do not see the pieces are done. Although the demolition of pieces to do out of the large pieces of ABS prototype in the beauty of the above with the overall processing of what the difference between the United States, but in terms of firmness and compression capacity of these aspects is far less than the CNC milling with one block, especially as a wheel of such products, Enterprises will choose the CNC milling with one block.
But in the Tuowei model, this large pieces of ABS prototype can be the CNC milling with one block. The following figure of the ABS prototype plate, the length of 1.2 meters, is the CNC milling with one block. If in the past, this is still difficult for us. But in October last year, Tuowei model introduced a new equipment, processing trip can reach 2000mm, so in the processing of this prototype plate when there is no pressure.
If you need to find a CNC milling with one block of large pieces of ABS prototype manufacturers, you can choose Tuowei model,