Tuowei shares the precautions of cnc machining center after the arrival of the goods

tuowei shares a complete list of precautions after the arrival of the cnc machining center. Precautions for handling Shenzhen prototype factory http://www . Sztuowei. Com machine tool consists of spindle box, base, slide seat, Workbench, Operation panel, cooling, pneumatic, lubrication, electrical cabinet, knife library and CNC system, except for the cooling part, all other parts are connected with wires, pipes, tubing, etc. , all of which are connected to each other on the base. There is no need to disassemble when handling. The whole machine is about 3 m long, suitable handling equipment is available. 2. Handling step . Preparation measures; B. Confirm that the position of hoisting rope or shovel foot is correct; C. Check the balance before the machine tool is raised, then slowly raise; D. Carefully slowly put down the machine, and must not suddenly collide with the ground; . 3. Handling with packing box: . The weight of the machine tool is about 6 tons, and the lifting capacity of the crane must be more than 7 tons; B. The load-bearing capacity of the lifting rope must be greater than 7 tons; C. Packing box size must pay attention to the accessibility during handling; D. Adjust the position of the lifting rope so that the lifting point is located on the center of gravity of the packing box, so as not to cause machine and personal injury caused by the tilt of the machine tool; E. Within the safety height allowed by the forklift, the forklift can also be used for direct forklift transportation; 4. Handling without packing box: handling with forklift (Suggestions). The net weight of the machine tool is about 6 tons, and the tonnage of the forklift must be more than 7 tons; B. The size of the machine tool is about 3050*2280*2700. It is necessary to pay attention to the accessibility during handling and remove all obstacles before handling; C. Adjust the position of the shovel, so that the center of gravity of the machine tool is stable, so as not to cause machine and personal injury caused by the tilt of the machine tool, shovel from the side of the machine tool, do not allow from the front or behind, shovel, at least 15cm away from any part of the machine tool and forklift; D. The shovel of the forklift is not allowed to lift too much to avoid personal injury and damage to the machine. 5. Using lifting equipment to carry two M20 hanging ear threaded holes under the Y forward rail shield of the machine tool, and the same two threaded holes on the end face of the column, four hanging ears can be used for lifting, pay attention to the rope when lifting and not in direct contact with the machine tool, so as not to scratch the machine paint or damage the parts on the machine itself.

There are a lot of businesses today that are very much in demand and one of them is a stereolithography process.
Do you want rapid prototyping manufacturers china rapid prototyping of digital systems? We also have prototype abs. visit Tuowei Model to know more.
Data has always been important in business, of course. But with the arrival of digital data—its volume, depth, and accessibility—it has become clear it is key to helping Shenzhen Tuowei Model Technologies Co., Ltd. develop sustainable competitive advantage.
stainless steel prototyping cnc material will help keep your metal rapid prototyping in a rapid prototyping services china state.
According to the market analysts, exports from Shenzhen Tuowei Model Technologies Co., Ltd. facilities in China will exceed the forecast.